DC 12V 24V input 4CH Wireless RF Remote Control Light Switch 10A Relay Output Radio Receiver Module Garage Doors/lamp

Note: DC 12V input and DC 24V input are available ,Please leave a message for our order, if there is no message  ，12V will be sent you !

433mhz and 315 mhz are available ,315mhz will be sent out if there is no demand on frequency !

Specifications:

Control Lights, TVs, Motors, Fans, Cameras, Video signals, Audio signals, electrically operated Doors/ Locks/ Windows.

1.Working Voltage: DC12V/24V ±10%

2.Current:Standby less than 10mA,Working less than 128mA

3.Working Temperature: -10'C—+60'C

4.Receiver Frequency: 315MHz/433.92MHZ

5.Receiving Sensitivity: -105dB

6.Output State: Switching Value

7.Max Load:10A Relay, Resistive load less than 8A,Inductive load less than 3A

8.Receiver Board Size:70*50*18mm

9.Case Size:75 * 55 * 30mm

Encoding Type: Learning Code

Add transmitter by the Learning Button on the receiver

 1.Control Mode  

Output State: It is adjusted by the Jumper on the Receiver Board,

Momentary-----Jumper on "1&2"

Toggle--------Jumper on "3&4"

Latched-------Jumper on 1 Pin or Take away the Jumper

1)Toggle/Self-Lock: Press->On;Press again->Off

press one button for one time is working/ON .press the same button again is stop/OFF .(1 channel switch(receiver) need 1 button remote control (transmitter).

2)Latched/Inter-Lock: Press->On;Press other button->Off

press one button is working/ON ,press another button is stop/OFF .( 1 channel switch( receiver) need 2 buttons remote control (transmitter).

3)Momentary/Jog: Press and hold->On;Release->Off

Keep pressing one button is working /ON.loosen your finger is stop/OFF .1 channel switch(receiver) need 1 button remote control (transmitter )

(Original Setting is  Momentary , Change it by yourself.)

Learning Method:

Input DC12V/24V Power for the receiver,press the learning button ,Green LED indicator OFF,Then press transmitter ,the LED indicator flash fast,It mean learning successfully.

Clearing Code:

Keeping press the learning button 8 seconds until the LED indicator ON, It mean the code have been cleared successfully.

Package included:

A : 1*receiver (with cover)

     1* transmitters(with battery)

B : 1*receiver (with cover)

      2* transmitters(with battery)

C : 1*receiver (with cover)

      3* transmitters(with battery)

D : 1*receiver (with cover)

      4* transmitters(with battery)

E : 1* transmitters(with battery)